Isuzu Truck NPR 4HF1 Crown Wheel And Pinion 8973201030 Bevel Gear

Engine Assembly and Engine Parts for More models as following:

Office:

More Spare Parts:

Packing:


Wearhouse:

Tips:

Pelvic corner tooth installation:

1. The pot corner teeth should be cleaned before installation, so that the surface is kept clean and rust-free. The inner ring of the bearing used should be used in one set at the same time, and in order to make the active wheel front and rear bearings have the correct clearance in the assembly, the actual size of the bearing used should be carefully measured to determine the total thickness of its gasket.

2. The bearing should be heated to about 80-94C when assembled, and then gently pressed to the front bearing neck.

3, tighten the nut M27X15-6g behind the active wheel, tightening torque between 400-450Nm, at this time the torque required to rotate the active gear is between 1.0-2.5Nm, hook the edge hole with a spring scale, and the flat force of the pull gear is between 16.34-40.87N.

4. After the main cone assembly is installed on the reducer shell, the driven wheel is installed, the coupling nut bolt with the differential shell is cleaned, and the fastening glue GY340# and LT271# are coated on the thread surface. Adjust the axial position of the driven wheel, so that the gear pair meshing clearance is between 0.2-0.4mm, and then carry out a trial operation to ensure that the position of the contact spot is in the middle of the tooth surface, the front surface is small, the reverse surface can be biased to the large end, and the width of the contact shift point is generally not less than 7mm.

Shenzhen Tai Trade Ltd, Specialized in Distributing Japanese Engine Assembly and Engine Spare Parts Since 2012. We have a large range of these Engine And Spare Parts Perfect Condition and High Quality, we can provide New and Used Engines, Spare Parts for ISUZU, MITSUBISHI, NISSAN, HINO, TOTOTA, KOMATSU, , KIA, HYUNDAI and so on.

Shenzhen Tai Trade Ltd, was established in 2002 as a special Flywheel and Ring Gear manufacturer named TWOO Auto Parts Power Factory. In 2010 we renamed to Twoo Auto Parts Co., Ltd and began to export by ourselves to all over the world. In order to expand our product line and supply more and complete service to customer, we set up our own trade company--- Twoo Auto Parts Co., Ltd in 2011.

Now we supply the Starter Motor, Alternator, Compressor, Flywheel, Clutch Parts, Crankshaft, Camshaft, Turbocharger, Brake Disc and so on. Our sales network begun from Europe and North America and now has spread to South Africa, South America, Australia, Middle East and other countries and regions.